Windsor SCX364 Instrucciones de operaciones Pagina 31

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 101
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 30
31
Maintenance
Front Side Squeegee
The front blade allows solution to pass through
channels in the blade into the squeegee assembly
while maintaining vacuum to provide lift. The front
blade has two wear surfaces and can be rotated for
extended life. The front blade should not require regular
replacement under normal use.
The rear blade wipes the floor to a near dry condition. It
is important the rear blade be in good condition to
properly do its job. As with the front, each squeegee
blade assembly has two wear surfaces for extended
service.
Check both the front and rear squeegee blades for
damage, wear, and adjustment each day in the pre-run
check. Change the front blade if it is torn or has an
uneven edge. Change the rear blade if it is less than
1/2 the original thickness.
Adjusting Squeegee
The squeegee assembly must have correct deflection
at each tip as well as the center. The knobs on the
squeegee linkage control the adjustment.
To Remove Squeegee Assembly
1. With the squeegee and deck in the up position,
and the swinging deck in the out position, turn key
switch "OFF".
2. Disconnect vacuum hose from squeegee and
loosen both mounting knobs.
3. Pull squeegee assembly rearward from the lifting
carrier.
4. Inspect or repair as necessary and reinstall.
FOR SAFETY: Before leaving or servicing
machine; stop on level surface, turn off machine
and remove key.
To Replace Or Rotate Front Side Squeegee
Blade
1. With the squeegee and deck in the up position, and
the swinging deck in the out position, turn key
switch "OFF".
2. Remove the squeegee from the machine. Remove
retaining nuts then remove the retainer strap and
squeegee blade.
3. Rotate the squeegee to new edge position or
replace as required. Each blade has two edge
positions. When installing the front blade, tighten
the center nut first. Insure that the retainer strap is
pressed against the blade before tightening the
outer nuts.
86037150 SCX364
Vista de pagina 30
1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 100 101

Comentarios a estos manuales

Sin comentarios