Windsor SCX364 Instrucciones de operaciones descargar pdf (Pagina 10)

100

101

Operations

How The Machine Works

The Saber Cutter is a battery powered, self-propelled,

hard floor scrubber intended for commercial use. The

appliance applies a cleaning solution onto a hard floor,

scrubs the floor with brushes, and then vacuums the

soiled water back into the recovery tank.

The machine's primary systems are the solution

system, scrub system, recovery system, and directional

control system.

The function of the solution system is to store cleaning

solution and deliver it to the scrub system. The solution

system consists of the solution tank, strainer, valve and

controls. The solution tank stores cleaning solution

(water and detergent) until it is delivered to the scrub

system. The strainer protects the valve from debris.

The valve is a solenoid type valve, which controls the

delivery of cleaning solution to the scrub system. The

valve automatically prevents solution flow unless the

scrub brushes are turned on and the machine is being

propelled. The solution control knob controls the

amount of cleaning solution delivered to the scrub

system by controlling the amount of time the valve is

open.

The function of the scrub system is to scrub the floor.

The scrub system consists of three rotary type disk

scrub brushes, motors, scrub deck skirt, lift mechanism,

swing mechanism and controls. The brushes scrub the

floor and the motors drive the brushes. The brush drive

hubs allow the scrub brushes to follow irregularities and

changes in the floor without loosing contact with floor.

The scrub deck skirt controls the cleaning solution on

the floor so that the squeegee can pick it up. The brush

lift mechanisms are controls used to raise and lower the

deck. The brush swing mechanisms are controls used

to swing the deck in and out.

The function of the recovery system is to vacuum the

soiled water back into the recovery tank. The recovery

system consists of two squeegees, vacuum motor, float

ball filter, recovery tank and controls. The squeegees

wipe the dirty solution off the floor as the machine

moves forward. The vacuum motor provides suction to

draw the dirty solution off the floor and into the recovery

tank. The recovery tank stores the dirty solution. The

float ball filter protects the vacuum fan from debris and

shuts off air going to the recovery tank when tank is full.

When flow of air is shut off the vacuum motor will

continue to run. At this time the recovery tank must be

drained.

The function of the directional control system is to

control the direction and speed of the machine. The

directional control system consists of the propel control

buttons, reverse button, speed control knob/potentiom-

eter, controller and transaxle. The propel controls

actuate switches which cause the machine to move

forward. For reverse motion depress the reverse

button while depressing one of the propel controls. The

speed control knob actuates a potentiometer, which

signals speed. The controller interprets the forward/

reverse signals from the switches and the speed signal

from the potentiometer to command the transaxle to

propel the machine in the direction, and at the speed,

desired.

86037150 SCX364

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 100 101

Comentarios a estos manuales

Sin comentarios

Windsor SCX364 Instrucciones de operaciones Pagina 10

Comentarios a estos manuales

Relacionado con productos y manuales para Depurador Windsor SCX364