Windsor SCOX324 Instrucciones de operaciones descargar pdf (Pagina 30)

MAINTENANCE

CUTTER 24V 86036830 06/20/07

4-12

12. ACTUATOR SCRUB DECK

REMOVAL/REPLACEMENT

FOR SAFETY: Before leaving or servicing

machine, stop on a level surface, turn off

machine and set parking brake (If option is

installed).

1. Remove front cover.

2. Remove the two nuts below the scrub deck that

attach the actuator bracket.

3. Remove clevis pin and rue ring from lower

bracket of actuator, make sure not allow actuator

bracket to rotate.

4. Disconnect actuator from wiring harness.

5. Remove upper clevis pin and rue ring from

actuator bracket.

6. Reverse steps to install.

SCRUB DECK ACTUATOR ADJUSTMENT

The actuator will need to be adjusted when replaced.

To adjust the actuator:

1. While holding actuator barrel to prevent it from

spinning, apply power to the actuator such that it

is fully extended. Positive power to white wire,

and negative/ground to black. Limit switch within

actuator will stop it.

2. Turn barrel out one or more full turns to assure

that when it is retracted it will not bind against

itself.

3. While holding actuator barrel to prevent it from

spinning, apply power to the actuator such that it

is fully retracted. Positive power to black wire,

and negative/ground to white wire. Limit switch

within actuator will stop it.

4. With actuator fully retracted, turn barrel in until it

touches the base of the threaded shaft.

5. At the bottomed out position, turn the barrel out

1 1/2 turns, then enough more to allow

connection to lift linkage.

6. Connect actuator to lift linkage.

7. Check travel of actuator during operation.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 90 91

Sin comentarios

Windsor SCOX324 Instrucciones de operaciones Pagina 30