Windsor CS24SP Manual de usuario descargar pdf (Pagina 55)

MAINTENANCE-TRANSPORTING

PUSHING MACHINE

The machine may be pushed for short distances at

speeds not to exceed 5 mph. Be careful to avoid

damaging machine. The machine may be pushed by

hand from the rear.

NOTE: To avoid damage caused by regenerative

voltage, disconnect traction motor before towing or

pushing machine.

MACHINE TIE-DOWNS

There are two tie points located at front and each side

of foot box frame and two at the front side of frame.

Tie-down devices must be of the proper type and

strength. The combined strength of all tie-downs must

be strong enough to lift two times the weight of the

machine. Tie-downs must be positioned to prevent

the machine from moving forward, backward, or either

side to side. Use all four corners of the machine with

the tie-downs running out opposite directions. Tie-

downs must be attached to the transporting vehicle

securely.

PREPARATION FOR LOADING /UNLOADING

TRAILER

Before loading or unloading machine from trailer,

remove squeegee, scrub deck, side skirts or side

squeegees, Aqua-Mizers and scrub brushes

(pads) to eliminate interference with tie-downs.

Scrub head must be in the up position before

NOTE: When transporting the machine on a trailer

or in a truck, in addition to using tie-downs, be

sure to set the parking brake, and block the tires to

prevent the machine from rolling.

TIE DOWN POINTS

4-28

86037660 CHARIOT 11/09/06

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 61

Sin comentarios

Windsor CS24SP Manual de usuario Pagina 55